Home About us Editorial board Search Ahead of print Current issue Archives Submit article Instructions Subscribe Contacts Login 
  Home Print this page Email this page Small font sizeDefault font sizeIncrease font size Users Online: 452  

   Table of Contents      
Year : 2015  |  Volume : 14  |  Issue : 1  |  Page : 16-18

Determination of Organ Doses in Radioiodine Therapy using Monte Carlo Simulation

1 Department of Medical Physics and Medical Engineering, School of Medicine, Isfahan University of Medical Sciences, Isfahan, Iran
2 Department of Medical Radiation Engineering, Science and Research Branch, Islamic Azad University, Tehran, Iran

Date of Web Publication2-Feb-2015

Correspondence Address:
Daryoush Shahbazi-Gahrouei
Department of Medical Physics and Medical Engineering, Isfahan University of Medical Sciences, Isfahan
Login to access the Email id

DOI: 10.4103/1450-1147.150517

PMID: 25709539

Rights and Permissions

Radioactive iodine treatment is a type of internal radiotherapy that has been used effectively for the treatment of differentiated thyroid cancer after thyroidectomy. The limit of this method is its affects on critical organs, and hence dosimetry is necessary to consider the risk of this treatment. Scope of this work is the measurement of absorbed doses of critical organs by Monte Carlo simulation and comparing the results with other methods of dosimetry such as direct dosimetry and Medical Internal Radiation Dose (MIRD) method. To calculate absorbed doses of vital organs (thyroid, sternum and cervical vertebrae) via Monte Carlo, a mathematical phantom was used. Since iodine 131 ( 131 I) emmits photon and beta particle, *F8 tallies, which give results in MeV were applied and the results were later converted to cGy by dividing by the mass within the cell and multiplying by 1.6E-8. The absorbed dose obtained by Monte Carlo simulations for 100, 150 and 175 mCi administered 131 I was found to be 388.0, 427.9 and 444.8 cGy for thyroid, 208.7, 230.1 and 239.3 cGy for sternum and 272.1, 299.9 and 312.1 cGy for cervical vertebrae. The results of Monte Carlo simulation method had no significant difference with the results obtained via direct dosimetry using thermoluminescent dosimeter-100 and MIRD method. Hence, Monte Carlo is a suitable method for dosimetry in radioiodine therapy.

Keywords: Absorbed dose, Monte Carlo simulation, phantom, radioiodine therapy, thyroid cancer

How to cite this article:
Shahbazi-Gahrouei D, Ayat S. Determination of Organ Doses in Radioiodine Therapy using Monte Carlo Simulation. World J Nucl Med 2015;14:16-8

How to cite this URL:
Shahbazi-Gahrouei D, Ayat S. Determination of Organ Doses in Radioiodine Therapy using Monte Carlo Simulation. World J Nucl Med [serial online] 2015 [cited 2021 Oct 16];14:16-8. Available from: http://www.wjnm.org/text.asp?2015/14/1/16/150517

   Introduction Top

Radioactive iodine therapy (RIT) is a type of internal radiotherapy. The treatment uses a radioactive form of iodine called iodine 131 ( 131 I). The radioactive iodine circulates throughout the body in the bloodstream. [1],[2],[3],[4],[5] Thyroid cancer cells pick up the iodine wherever they are in the body. The radiation in the iodine then kills the cancer cells. RIT affects other vital organs. Therefore, it is important to properly assess the benefits and risks to a patient from this procedure. One factor, that strongly influences the intensity or probability of radiation effects, is the energy absorbed by the tissue (absorbed dose), this assessment can be performed only if one knows the radiation dose that will be delivered to other organs by RIT. In nuclear medicine procedures, it is almost impossible to measure the radiation dose directly using any kind of radiation detector. Instead, this has to be calculated by using a variety of physical and biological data and mathematical equations specially developed for this purpose. The use of a well-supported radiation transport code such as Monte Carlo N-Particles (MCNP) with the knowledge of patient anatomy will result in a significant improvement in the accuracy of dose calculations. [5],[6],[7],[8]

The scope of this study was to obtain absorbed dose of organs using MCNP simulation method and then comparing the results with Medical Internal Radiation Dose (MIRD) method and experimental method thermoluminescent dosimeter (TLD).

   Materials and Methods Top

For the theoretical simulations of the thyroid, sternum and cervical vertebrae MIRD mathematical phantom which, described in previous work, have been used. [2] The mathematical phantom is a representation of the human body. In these phantoms, all organs are represented with geometrical bodies (such as cylinders, ellipsoids, tori, etc.), which are described with suitable mathematical equations. A corresponding chemical constitution for various types of organ tissues is also defined. [8] The density of the sternum and cervical vertebra is noted to be 1.4 g/cm 3 and the density of thyroid is noted to be 1.04 g/cm 3 .

To simulate the problem with MCNP, an input file that describes the geometry of the problem, specifies the materials and the source, and defines the desired result from the simulation, must be prepared.

The desired result for this study is absorbed doses of vital organs (thyroid, sternum and cervical vertebra). To calculate absorbed dose using Monte Carlo simulation, either F6 tallies or *F8 tallies can be used but since 131 I emits both photons and beta particles and F6 tallies were not defined for beta particles, for this reason, *F8 tallies were used for calculating the absorbed doses in this study. However, we calculated the absorbed doses of photons emitted by 131 I by both *F8 and F6 tallies to compare the results of these two tallies with each other. The *F8 tallies, which give results in MeV, were later converted to Gy by dividing by the mass within the cell and multiplying by 1.6E-10 to convert the units from MeV/g to J/kg 1 (Gy) or 1.6E-8 to convert the units to cGy. The mass within the cell was determined by multiplying the density of the material in the cell by the volume of the cell. The F6 tallies, which give results in MeV/g 1 , were converted to Gray (Gy) with the tally multiplier card (FM card). The simulation was done for 10 6 particles and relative error was decreased by using variance reduction techniques to <0.001 for each organ.

Since MCNP gives the results per disintegration, so to calculate the absorbed dose of administrated activity, it is necessary to multiply the result by accumulated activity in source organ (thyroid). The accumulated activity was estimated in the previous work. [4] Briefly, in the place of two lobes of thyroid two bottles of 5 mCi of 131 I were used, and TLDs were placed on the surface of the thyroid phantom for 24 h. Subsequently, dose measurement on patients and phantom were compared. Because the amount of activity in phantom was known, the amount of iodine in patient thyroid could be estimated. [4],[5]

   Results Top

The results are divided into three groups of 100, 150 and 175 mCi that is based on the therapeutic dose administrated to patients. [Table 1] summarizes the results of absorbed doses of photons, calculated by F6 and *F8 tallies. [Table 2] summarizes the results of absorbed doses of photons and beta particles, calculated by *F8 tallies. Note that [Table 1] and [Table 2] are the rare results of MCNP and some calculations have done to get the absorbed doses of organs for the administrated activity to patients.
Table 1: Absorbed doses of photons

Click here to view
Table 2: Absorbed doses of photons and beta particles calculated by *F8

Click here to view

[Table 3] shows the amount of 131 I in thyroid obtained by comparison of absorbed dose in patients and phantom which was estimated in the previous study. [4]
Table 3: The activity obtained by use of phantom

Click here to view

[Table 4] shows the results of MCNP simulation after applying the necessary calculation on results of [Table 2].
Table 4: Results of MCNP simulation (cGy)

Click here to view

[Table 5] also summarizes the result of calculating methods of MCNP simulation compared to MIRD method [5] and experimental methods (TLD). [4]
Table 5: Results of three different methods of dosimetry

Click here to view

   Discussion Top

Internal radiation dosimetry of radiopharmaceuticals is an important aspect of nuclear medicine to weigh risk versus benefit considerations. However, since implantation of many dosimeters in the human body is undesirable (or impossible), the doses of internal organs are not measurable and some dose calculation has to be applied. [5] Monte Carlo techniques have been used extensively in Medical Physics applications and offer the most powerful tool for modeling radiation transport in different media. [3],[4]

Comparing the results of absorbed doses of organs obtained by F6 and *F8 tallies for photon, it's obvious that there's no significant difference between the results of these two different tallies but since F6 is not defined for beta particles and 131 I emits beta particles as well as photons, *F8 is used for the purpose of calculating of absorbed doses of organs in this study.

The beta rays emitted from 131 I travel a maximum distance of 3 mm in tissue and as it's shown in [Table 2], the results of *F8 tallies for beta particles in sternum and cervical vertebrae are quite negligible. The thyroid has the greatest amount of absorbed dose. Absorbed doses in studied organs will be decrease as the administrated activity decreases.

As shown in [Table 5], the results of three different methods of dosimetry are in a good agreement. However, the results of MCNP simulation and MIRD calculation are closer to each other than TLD measurement and that could be due to the fact that both of these method are based on the phantom of reference human data and on the other hand because of inability of TLD in measuring the absorbed dose of beta rays emitted from 131 I because as it's said before the maximum distance that the beta rays emitted from 131 I travel in tissue is 3 mm, and they do not contribute to measured dose by TLDs.

Although MCNP simulation is an effective, fast and cost-effective method in dosimetry of internal organs, but it also has its own limitations. For example, it's based on reference human data, and this could be a source of error in estimation of absorbed doses of different patients. However, estimating the mass of every patient's thyroid via scanning decreases this error. [8] On the other hand, the accuracy of absorbed dose of internally distributed radiopharmaceuticals estimated by the MCNP method depends on the cumulated activity of the source organs and their mass. The usual methods for obtaining the cumulated activity are, positron emission tomography, single photon emission computed tomography, extrapolation from animal data, calculations based on the mathematical biokinetic model and use of TLD. [9],[10] In this study, the source activity was estimated by using TLD dosimetry, which means that the source of error in TLD dosimetry affect the results of the simulation.

   Conclusions Top

Monte Carlo simulation is a suitable and cost-effective method for dosimetry in radioiodine therapy and since the results of MCNP simulation, MIRD calculations, and experimental dosimetry are in good agreement with each other, it's possible to use any of these methods instead of each other by the clinician.

   References Top

Hänscheid H, Lassmann M, Luster M, Thomas SR, Pacini F, Ceccarelli C, et al. Iodine biokinetics and dosimetry in radioiodine therapy of thyroid cancer : p0 rocedures and results of a prospective international controlled study of ablation after rhTSH or hormone withdrawal. J Nucl Med 2006;47:648-54.  Back to cited text no. 1
Shahbazi-Gahrouei D, Cheki M, Moslehi M. Estimation of organ absorbed doses in patients from (99m)Tc-diphosphonate using the data of MIRDose software. J Med Signals Sens 2012;2:231-4.  Back to cited text no. 2
[PUBMED]  Medknow Journal  
Shahbazi-Gahrouei D, Ayat S. Comparison of three methods of calculation, experimental and monte carlo simulation in investigation of organ doses (thyroid, sternum, cervical vertebra) in radioiodine therapy. J Med Signals Sens 2012;2:149-52.  Back to cited text no. 3
[PUBMED]  Medknow Journal  
Shahbazi-Gahrouei D, Nikzad S. Determination of organ doses in radioiodine therapy using medical internal radiation dosimetry (MIRD) method. Iran J Radiat Res 2011;8:249-52.  Back to cited text no. 4
Shahbazi-Gahrouei D, Nikzad S, Shokrani P, Shahi Z, Monadi S. Determination of absorbed dose of organs (thyroid, sternum, cervical vertebra) in thyroid cancer patients following radioiodine therapy. Iran J Nucl Med 2009;17:27-33.  Back to cited text no. 5
Nieuwlaat WA, Hermus AR, Ross HA, Buijs WC, Edelbroek MA, Bus JW, et al. Dosimetry of radioiodine therapy in patients with nodular goiter after pretreatment with a single, low dose of recombinant human thyroid-stimulating hormone. J Nucl Med 2004;45:626-33.  Back to cited text no. 6
Brans B, Bodei L, Giammarile F, Linden O, Luster M, Oyen WJ, et al. Clinical radionuclide therapy dosimetry : t0 he quest for the "Holy Gray". Eur J Nucl Med Mol Imaging 2007;34:772-86.  Back to cited text no. 7
de Carvalho AB Jr, Hunt J, Silva AX, Garcia F. Use of a voxel phantom as a source and a second voxel phantom as a target to calculate effective doses in individuals exposed to patients treated with 131 I. J Nucl Med Technol 2009;37:53-6.  Back to cited text no. 8
Tandon P, Soni PS, Bhatt BC. Estimation of absorbed dose for 99 mTc on the surface of biological organs of REMCAL phantom. Indian J Nucl Med 2003;18:62-5.  Back to cited text no. 9
  Medknow Journal  
Yand D, Beril T. A new approach for the calculation of critical organ dose in nuclear medicine applications. J Radiat Isot 2005;62:405-10.  Back to cited text no. 10


  [Table 1], [Table 2], [Table 3], [Table 4], [Table 5]

This article has been cited by
1 The impact of different computational assumptions in 131 I dosimetry for hyperthyroidism therapy
Mohammad Abuqbeitah,Sait Sager,Mustafa Demir,Nami Yeyin,Burak Akovali,Kerim Sönmezoglu
Medical Physics. 2020;
[Pubmed] | [DOI]


    Similar in PUBMED
   Search Pubmed for
   Search in Google Scholar for
 Related articles
    Access Statistics
    Email Alert *
    Add to My List *
* Registration required (free)  

  In this article
    Materials and Me...
    Article Tables

 Article Access Statistics
    PDF Downloaded484    
    Comments [Add]    
    Cited by others 1    

Recommend this journal